Tools needed: Heat Gun or Hair Dryer, Scissors and Trimming exacto knife.

Note: Do not use water or liquid to install, it will soak into adhesive causing problems.

1. Thoroughly clean your plastics, removing all old adhesive, dirt, lint, oils, etc. When done rinse with plain water and dry with lint free cloth.

2. Remove Half of the back liner and cut off. Line up bolt holes where liner is still attached.

3. Place decal lightly onto plastics making sure bolt holes and vents are lined up properly.  If it gets misaligned, lift up decal and fix. Start from center and work your way to the edge pressing firmly to activate the adhesive.

4. If decal wants to wrinkle use heat gun to soften and press center of wrinkle down to make smooth.

Tip: We Recommend that you do not ride for atleast 24 hours after installation.  After all done use heat gun on edges and rest of decal to help proper adhesion.